Drawings or pictures may show non-standard equipment.

BOLLARD™ 65kW Marine Generator

SKU: MGP65 Category: Tags: ,

The BOLLARD™ MGP65 will carry the load over the long haul.

Over 55 years of design experience and excellence has produced this model featuring an industry leading 4.5 liter turbocharged engine.

Matched to a high-efficiency motor starting generator and built to be a BOLLARD™, there is no other machine at this power rating which can match in reliability, durability, and provide the lowest operating cost. Add on the SeaDrive™ option to drive your hydraulics.

Count on BOLLARD™ to pull harder.

EPA certified Tier 3 Marine, CARB, EU & MOC


Standard Equipment

  • John Deere 1800 RPM, EPA/CARB certified Tier 3 marine diesel engines
  • Marathon motor start generator rated 80C/40C for maximum electrical efficiency
  • Dedicated PMG excitation with 300% short circuit protection and VFD compatibility
  • Digital parallelable automatic voltage regulator – .25% voltage regulation no load to full load
  • Remote start digital control panel with J1939 diagnostics and 3′ extension harness
  • Automatic safety shutdowns for low oil pressure, high water temp and over speed
  • Structural steel welded base frame with vertical and horizontal gusset supports
  • Coast Guard approved JIC fuel supply and return line fittings installed
  • Isoflex™ anti-vibration mounts between engine/generator and base frame
  • Closed crankcase engine ventilation filter system
  • Dry element cleanable combination air intake filter/intake silencer
  • Dry exhaust elbow with mating flange, high temperature gasket and stainless hardware
  • Coolant recovery bottle
  • Starter and alternator 12V std on 40kW-150kW, 24V std 200kW-385kW
  • Imron™ two-part epoxy marine paint for maximum corrosion protection
  • Stainless steel fasteners and powder coated accessory brackets
  • All generators are calibrated, and load tested under full load before shipment
  • Single phase 4 wire generators are oversized to allow full load single phase output 105/40c @ 1.0PF
  • Three phase generators are 12 lead reconnectable voltage, 50Hz or 60HZ
  • Heat exchanger cooled engines include bronze gear driven raw water pumps and Cu/Ni HE cores
  • Stainless steel water injected exhaust elbows are Included with HE cooled engines

Download the brochure


Engine Model4045TFM85
Engine TypeIn-Line | 4 Cycle | 4 Cylinder | Diesel
Displacement – L (cu.in)4.5 (275)
Bore x Stroke – mm (in)106 (4.17) x 127 (5.00)
Oil Sump Capacity – qts (L)19 (18)
Emission RegulationEPA Commercial Marine Tier 3
Prime – 60hz, 1800RPM (HP)65 kW (87)
Standby – 60hz, 1800RPM(HP)71.5 kW (96)
Motor Starting Range – HP23.5 – 65 (Code G Motor @ 208VAC)
Voltage Regulation+/-25%
Starter12v | 4.5kW
Alternator12v | 75 Amp
Operating Angle – Degrees20 (Constant) | 30 (Intermittent)
Dry Weight – lbs2028 (engine, 362 gen, skid)
Length x Width x Height – in(See brochure for details)


Single Circuit Keel Cooling Package
Single Circuit Heat Exchange Package
Single Circuit Marine Radiator Package

Motor Starting Upgrade Options
(Code G Motor @ 208VAC)
Up to 1:1 HP per kW

Air Intake & Filtration
K&N Air Filters
Donaldson Air Silencer
Closed Crank Case Vent Loop

Controls & Instrumentation
Control Panel
Custom Harness Length
Auxiliary Start Panel
Auto Start/Stop
Pre-Alarm Senders
AC Meter Panel
Low Coolant Level Shutdown
High Water Temp. Shutdown
Low Oil Pressure Shutdown
Low Oil Level Gauge/Shutdown
Overspeed Shutdown
Paralleling & Load Share
Over-Voltage Alarm
Over-Current Alarm
Under-Current Alarm

DC Electrical System
Battery: 12v | 24v
Battery Rack & Cables
Battery Isolation Switch

Fuel-Lube Oil System
SCOR™ Oil Regeneration System
Oil Drain Extension W/ Valve
Oil Drain Pump to Engine
Move Dipstick To Opposite Side
High/Low Oil Level Shut Down
Custom Oil Drain Hose Length
Single Side Service
Lube Oil Drip Pan

SS Wet Exhaust Mixing Elbow
Dry Exhaust Matching Flange
SUPERFLEX™ Exhaust Bellows
Cowl & EM Exhaust Silencers
Heat Recovery Silencer

Power Take Off
SEADRIVE™ Clutched Front PTO
Clutch: Air | Oil | Electric
SEADRIVE™ Direct Drive Front PTO
Aux. A/B 2 Sheave Universal Pulley
Aux. A/B 4 Sheave Universal Pulley
Additional Belts

Additional Options
Sea Trial Start-Up
MER Site Start-Up w/ Load Bank
Custom Frame / Skid
Dual Vibration Isolation Mounts
Custom Sound Enclosure
Galvanized or Powder Coated Skids & Accessories
Racor Fuel Water Separator